Cut and break trims with a minimum width of 20 mm. In addition to scoring the float glass, the BCS cutting bridge can be used to label, to cut the laminated glass to shape, to remove the Low-E on all types of sheets based on the chosen set-up (see specific BCS catalogue) and, when combining the two machines, can assist the 520 LAMe during sheet positioning, thanks to a specific suction cup system.
The 548 LAM can be conbined with a belt loading table. Breakout and detachment of 20 mm trims and automatic positioning for diagonal cuts ensure fully automatic, high production. If combined with the float glass cutting table, the bridge can also be used to label, to cut the laminated glass to shape, to remove the Low-E on all types of sheets based on the chosen setup (see specific catalogues BCS/EVO).